Mouldable Ribbon auto-amalgamant silicone (3 m) MATT CHEM X SYSTEM +.

Mouldable Ribbon auto-amalgamant silicone - COLORLESS

Air - water impermeability. Hermetic to moisture. Works-50 ° to + 260 ° C.

Insulation 8000 Volts (layered unstretched)

Auto-amalgamant and isolating silicone tape. X SYSTEM + resistant to very high temperatures, pressure, high-voltage, to sea water, UV, acids, to mold, to corrosion.

• Is self-fusing... Has no Agents adhesives

• Resistant to 260 ° C

• Remains Flexible up to-50 ° C

• Resistance to stretching staggering 700 PSI (48 Bar; 4.8 MPa)

• Insulation of 8000 Volts per layer (> 15000 volt/mm)

• 300% elasticity

• Resistant to acids, Fuels, oils, solvents, water salty, rays UV

Clean the surface and cut a piece of Ribbon (usually 15-20 cm). Remove and discard the plastic film. Keep the Ribbon clean and dry. Start by wrapping the Ribbon without overlay, but completely on itself. Stretch the tape while coil operation, superimposing the Ribbon 50% off himself, 50% on the room. In high-pressure, use at least 2 layers of ribbons or stretch more Ribbon. The last layer of tape should be put on the previous layers.

X SYSTEM + begins to be auto-fusionner immediately with a cohesive bond and permanent within 24 hours. A repositioning is not recommended after 2 minutes. Keep somewhere dry.

Roll of 3 m / width 25.4 mm